Clicking the Yellow Reset to Defaults Button on an exposed Value for struct Arrays always defaults to '0'

When using the track builder plugin, the default settings for the track width starts at 1. However, when the yellow arrow is clicked to to restore the track back to default it sets it to zero instead.

NEW REPRO

1. Open QAGame in editor.
2. Create and open a new blueprint struct.
3. Set the member variable to float.
4. Set the Default Value to 5.0.
5. Save and close the struct.
6. Create and open a new actor blueprint.
7. Add a variable based on your struct and make it an array.
8. Mark the variable as editable.
9. Compile the blueprint.
10. Add the blueprint to the level.
11. Select the blueprint instance.
12. Add an array entry.
13. Set the float to any value.
14. Click the Reset to Defaults arrow.

RESULT

The value resets to 0.0 as opposed to 5.0

OLD REPRO

1. # Open UE4 Launcher
2. Go to Learn Tab
3. Download Blueprint Splines Track (if not already downloaded)
4. Add the plugin to a blank level
5. Open The blank level
6. Go to the Blueprints Folder
7. Drag and Drop a copy of the "Track Generator" into the level
8. Add a few segments of track by Alt+ Drag
9. Set the track width to "Default" by clicking the little yellow arrow next to the setting in the Details panel under the Track Setup section
10. Notice the Track width is set to Zero instead of One (which it started at)

Note: If you Open the TrackGenerator BP and the Road Data Struct you'll notice that the Default TrackWidth is set to '1' and not 0.