All ELinearConstraintMotion pins in BP reset to "Free" when converting a project to 4.26

When using any of the Set Linear Limit nodes (X/Y/Z) and converting a project from a previous version of the engine, the nodes get their Constraint Type value reset to Free. I tested this with project made in 4.25.4 as well as 4.21.2.

When testing a project made in 4.21 and converting it into 4.25.4 @ CL 14469661 this did NOT occur so marking as a Regression

1. In 4.25.4 or an earlier version of the editor, create a new project
2. Open the level blueprint
3. Add a "Begin Play" and "Add Physics Constraint Component" node
4. Place a Set Linear XLimit node
5. Connect it to the physics constraint component node
6. Set Constraint Type to "Limited"
7. Save the project
8. Open the project in 4.26.1
9. Select "Convert In Place"
10. Open the level blueprint

RESULT:

The constraint type pin on the Set Linear XLimit node has been reset to Free

EXPECTED:

The constraint type would maintain its value when converting to a newer version of the editor